SdHci.h

Go to the documentation of this file.

 
#ifndef _SD_HCI_H_
#define _SD_HCI_H_
 
//
// SD Host Controller MMIO Register Offset
//
#define SD_HC_SDMA_ADDR           0x00
#define SD_HC_ARG2                0x00
#define SD_HC_BLK_SIZE            0x04
#define SD_HC_BLK_COUNT           0x06
#define SD_HC_ARG1                0x08
#define SD_HC_TRANS_MOD           0x0C
#define SD_HC_COMMAND             0x0E
#define SD_HC_RESPONSE            0x10
#define SD_HC_BUF_DAT_PORT        0x20
#define SD_HC_PRESENT_STATE       0x24
#define SD_HC_HOST_CTRL1          0x28
#define SD_HC_POWER_CTRL          0x29
#define SD_HC_BLK_GAP_CTRL        0x2A
#define SD_HC_WAKEUP_CTRL         0x2B
#define SD_HC_CLOCK_CTRL          0x2C
#define SD_HC_TIMEOUT_CTRL        0x2E
#define SD_HC_SW_RST              0x2F
#define SD_HC_NOR_INT_STS         0x30
#define SD_HC_ERR_INT_STS         0x32
#define SD_HC_NOR_INT_STS_EN      0x34
#define SD_HC_ERR_INT_STS_EN      0x36
#define SD_HC_NOR_INT_SIG_EN      0x38
#define SD_HC_ERR_INT_SIG_EN      0x3A
#define SD_HC_AUTO_CMD_ERR_STS    0x3C
#define SD_HC_HOST_CTRL2          0x3E
#define SD_HC_CAP                 0x40
#define SD_HC_MAX_CURRENT_CAP     0x48
#define SD_HC_FORCE_EVT_AUTO_CMD  0x50
#define SD_HC_FORCE_EVT_ERR_INT   0x52
#define SD_HC_ADMA_ERR_STS        0x54
#define SD_HC_ADMA_SYS_ADDR       0x58
#define SD_HC_PRESET_VAL          0x60
#define SD_HC_SHARED_BUS_CTRL     0xE0
#define SD_HC_SLOT_INT_STS        0xFC
#define SD_HC_CTRL_VER            0xFE
 
//
// The transfer modes supported by SD Host Controller
// Simplified Spec 3.0 Table 1-2
//
typedef enum {
  SdNoData,
  SdPioMode,
  SdSdmaMode,
  SdAdmaMode
} SD_HC_TRANSFER_MODE;
 
//
// The maximum data length of each descriptor line
//
#define ADMA_MAX_DATA_PER_LINE  0x10000
#define SD_SDMA_BOUNDARY        512 * 1024
#define SD_SDMA_ROUND_UP(x, n)  (((x) + n) & ~(n - 1))
 
typedef enum {
  SdCommandTypeBc,  // Broadcast commands, no response
  SdCommandTypeBcr, // Broadcast commands with response
  SdCommandTypeAc,  // Addressed(point-to-point) commands
  SdCommandTypeAdtc // Addressed(point-to-point) data transfer commands
} SD_COMMAND_TYPE;
 
typedef enum {
  SdResponseTypeR1,
  SdResponseTypeR1b,
  SdResponseTypeR2,
  SdResponseTypeR3,
  SdResponseTypeR4,
  SdResponseTypeR5,
  SdResponseTypeR5b,
  SdResponseTypeR6,
  SdResponseTypeR7
} SD_RESPONSE_TYPE;
 
typedef struct _SD_COMMAND_BLOCK {
  UINT16    CommandIndex;
  UINT32    CommandArgument;
  UINT32    CommandType;                              // One of the SD_COMMAND_TYPE values
  UINT32    ResponseType;                             // One of the SD_RESPONSE_TYPE values
} SD_COMMAND_BLOCK;
 
typedef struct _SD_STATUS_BLOCK {
  UINT32    Resp0;
  UINT32    Resp1;
  UINT32    Resp2;
  UINT32    Resp3;
} SD_STATUS_BLOCK;
 
typedef struct _SD_COMMAND_PACKET {
  UINT64              Timeout;
  SD_COMMAND_BLOCK    *SdCmdBlk;
  SD_STATUS_BLOCK     *SdStatusBlk;
  VOID                *InDataBuffer;
  VOID                *OutDataBuffer;
  UINT32              InTransferLength;
  UINT32              OutTransferLength;
} SD_COMMAND_PACKET;
 
#pragma pack(1)
 
typedef struct {
  UINT32    Valid     : 1;
  UINT32    End       : 1;
  UINT32    Int       : 1;
  UINT32    Reserved  : 1;
  UINT32    Act       : 2;
  UINT32    Reserved1 : 10;
  UINT32    Length    : 16;
  UINT32    Address;
} SD_HC_ADMA_DESC_LINE;
 
typedef struct {
  UINT32    TimeoutFreq   : 6; // bit 0:5
  UINT32    Reserved      : 1; // bit 6
  UINT32    TimeoutUnit   : 1; // bit 7
  UINT32    BaseClkFreq   : 8; // bit 8:15
  UINT32    MaxBlkLen     : 2; // bit 16:17
  UINT32    BusWidth8     : 1; // bit 18
  UINT32    Adma2         : 1; // bit 19
  UINT32    Reserved2     : 1; // bit 20
  UINT32    HighSpeed     : 1; // bit 21
  UINT32    Sdma          : 1; // bit 22
  UINT32    SuspRes       : 1; // bit 23
  UINT32    Voltage33     : 1; // bit 24
  UINT32    Voltage30     : 1; // bit 25
  UINT32    Voltage18     : 1; // bit 26
  UINT32    Reserved3     : 1; // bit 27
  UINT32    SysBus64      : 1; // bit 28
  UINT32    AsyncInt      : 1; // bit 29
  UINT32    SlotType      : 2; // bit 30:31
  UINT32    Sdr50         : 1; // bit 32
  UINT32    Sdr104        : 1; // bit 33
  UINT32    Ddr50         : 1; // bit 34
  UINT32    Reserved4     : 1; // bit 35
  UINT32    DriverTypeA   : 1; // bit 36
  UINT32    DriverTypeC   : 1; // bit 37
  UINT32    DriverTypeD   : 1; // bit 38
  UINT32    DriverType4   : 1; // bit 39
  UINT32    TimerCount    : 4; // bit 40:43
  UINT32    Reserved5     : 1; // bit 44
  UINT32    TuningSDR50   : 1; // bit 45
  UINT32    RetuningMod   : 2; // bit 46:47
  UINT32    ClkMultiplier : 8; // bit 48:55
  UINT32    Reserved6     : 7; // bit 56:62
  UINT32    Hs400         : 1; // bit 63
} SD_HC_SLOT_CAP;
 
#pragma pack()
 
EFI_STATUS
SdPeimHcReset (
  IN UINTN  Bar
  );
 
EFI_STATUS
SdPeimHcEnableInterrupt (
  IN UINTN  Bar
  );
 
EFI_STATUS
SdPeimHcGetCapability (
  IN     UINTN        Bar,
  OUT SD_HC_SLOT_CAP  *Capability
  );
 
EFI_STATUS
SdPeimHcCardDetect (
  IN UINTN  Bar
  );
 
EFI_STATUS
SdPeimHcInitHost (
  IN UINTN  Bar
  );
 
EFI_STATUS
SdPeimSwitch (
  IN     SD_PEIM_HC_SLOT  *Slot,
  IN     UINT8            AccessMode,
  IN     UINT8            CommandSystem,
  IN     UINT8            DriveStrength,
  IN     UINT8            PowerLimit,
  IN     BOOLEAN          Mode,
  OUT UINT8               *SwitchResp
  );
 
EFI_STATUS
SdPeimRwSingleBlock (
  IN SD_PEIM_HC_SLOT  *Slot,
  IN EFI_LBA          Lba,
  IN UINT32           BlockSize,
  IN VOID             *Buffer,
  IN UINTN            BufferSize,
  IN BOOLEAN          IsRead
  );
 
EFI_STATUS
SdPeimRwMultiBlocks (
  IN SD_PEIM_HC_SLOT  *Slot,
  IN EFI_LBA          Lba,
  IN UINT32           BlockSize,
  IN VOID             *Buffer,
  IN UINTN            BufferSize,
  IN BOOLEAN          IsRead
  );
 
EFI_STATUS
SdPeimIdentification (
  IN SD_PEIM_HC_SLOT  *Slot
  );
 
VOID
SdPeimFreeTrb (
  IN SD_TRB  *Trb
  );
 
#endif